Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Guys,
recently i bought one 887 and 881 routers to connect them to my ISP modem, but i notice that NAT seems is not supported, so like that i cannot use the router because to send the traffic to the ISP i need nat overload.
is there any solut...
Hello Guys, i am having the same issue WLC management ip address is not reachable and WLC cannot reach the DG, even though everything look ok interface port of the WLC is tagged with the management vlan and vlan tagged across all the switches. did ma...
Hello,
i am having the same issue as you, and i appreciate if you can help me to fix the issue i am having the below error message on the AP.
The certificate (SN: 6F5328F20000000F6A57) is not yet valid Validity period starts on 13:39:13 UTC N...
Nat works only as below, but the issue the LAN ports is assigned to vlan 2 and i have multiples vlans on the access switch, so traffic will be blocked and only vlan2 traffic will be allowed, i have no idea how to make it works with NAT.
i can only co...
Router(config)#int Fa0Router(config-if)#ip natRouter(config-if)#ip nat ?% Unrecognized commandRouter(config-if)#ip nat
looks like the router doesn't accept the command so it is not supported by this router.
