About tmarlow

tmarlow · 09-20-2013

I'm confused and none of the documents I'm reading is helping. I'm trying to do a local SPAN session on an ASR9K. I'm using source ports that are sub-interfaces, like te0/4/0/5.1024 (but do not have the "l2transport" option enabled). My destinatio...

tmarlow · 02-04-2010

We're moving to ASR and OC3s instead of 7200VXR with DS3s. I have a question about the BITs ports on the RPs. I have BITs connections, but I also know that the internal BITs clock is stratum III and our BITs clock is stratum I or II.How do I config...

tmarlow · 10-02-2009

I'm trying to figure out why everytime that I see a policy-map configured, it doesn't take into account the routing protocols, why is that?I want to remark all traffic coming into our network from our BGP upstreams to be dscp 0, but I'm afraid of mes...

tmarlow · 06-11-2009

I'm trying to develop a good template for bonding T1s together using MLPPP.So the member serial interfaces need to have WFQ disabled or keep it enabled? Should CEF be disabled on the multilink interface or should it be left enabled? I'm trying to f...

tmarlow · 06-16-2008

There is a document called:Metro Ethernet 3.1 Design and Implementation GuideHow do I get hold of this? I can't locate it on CCO.

tmarlow · 09-20-2013

This is my config I just tried. Still, no packets. I removed the bundle-ether interface that I was also looking at to get rid of the LACP messages. So only the L2 broadcasts were coming across, I can't seem to pick up any L3 traffic and this is so...

tmarlow · 02-05-2010

Hey Cisco,There isn't very good documentation on this clocking topic and it is hard to understand how the ASR is going to use the BITs clock provided to the RP1s. Look below and see, what is "Valid but not present" mean. And if I type the below, am...

tmarlow · 10-14-2009

I want to remark all external traffic entering the network to be dscp 0. I do not want this to affect the bgp communications between the two routers though. This is the same device that is accepting the bgp packets from the upstream device.

tmarlow · 06-11-2009

What's the reason for "no fair-queue" on the serial interface.

tmarlow · 12-04-2008

Sure, these boxes were 7206VXRs that we originally had 8port serial octopus cables plugging into a paradyme comsphere CSU/DSU nest. We had two of these chassis and never thought in our wildest dreams that we would fill them up. Well, it was less th...

Member Since	‎08-16-2001 11:17 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	43

User Statistics

User Activity

SPAN on ASR9K just doesn't work

ASR1006 channelized OC3 and BITs reference

QoS remarking to dscp 0

Correct MLPPP configuration for T1s

Metro E Design Guide 3.1

Re: SPAN on ASR9K just doesn't work

Re: ASR1006 channelized OC3 and BITs reference

Re: QoS remarking to dscp 0

Re: Correct MLPPP configuration for T1s

Re: ospf point to point links on a lan