Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am downgrading a PIX Firewall from 7.0 to 6.3. I faced probelm when rebooting the PIX.The error shown as below,Booting first image in flashImage must be at least 7-0-0-0 error in file flash:/pix635.binNo bootable image in flash. Please download ...
Hi,Please see the attached screenshot. I have problem with my RME hardware report.The message show:Vendor type enumeration for this chassis not available in Old cisco chassis Mib -ChassisType(351)What will be the consequences for this message?thksReg...
Hi, I have 1 windows XP workstation connecting 2 switches on separate network. Let call the 2 switches - Switch 1 & switch 2I found that bpdu packet has been porpagate from switch 1 to switch 2 through my windows xp workstation.My windows XP workstat...
Hi,I cannot find this command sysopt route dnat in Pix 7.1. Any idea is this command deprecated or enable by default.Are there any new commands that should be considered for hardening of Cisco PIX firewalls?
Hi Ankur,The 2 switches are in separate network. Physically there is not any connection between this 2 switches. This 2 switches connect to each other only through the windows XP workstation. Workstation NIC 1 connect to switch 1 in vlan 7, NIC 2 con...
Hi dgahm,I got short of ports. So i am thinking of whether can use stackwise port to replace normal copper or fiber port.Besides, the throughput is higher.Steven Hoo
hi dgahm,Can this stackwise port replace fiber port or Ethernet port. Which mean i do not want to see 2 switches as one virtual switch. regards,Wan Hwai
Hi,1.How if i ask my local ISP about the framing format for oversea site?DO you think they know?2.Now the connection is up but there are a lot of error for both end router serial interface.3. If i change the oversea framing format CRC4, do you think ...
