Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to enable WOL for remote locations and after enabling direct broadcast on the LAN interface of the remote location it works just fine. Now I am trying to create an access list to allow the magic packets from only 1 server at the central l...
I have 4 Cisco 3750's layer 2/3 in a stack that is used for server and core connectivity. There are 3 VLAN's for a hyperv cluster, one for iscsi traffic, one for heartbeat/live migration cluster traffic and one for a virtual switch and all other serv...
I'd like to connect a Cisco 3750 stack (2 switches) to a 3560G using 2 fiber links, one to each of the 3750's in the stack for redundancy in case a 3750 goes out and to have 2 gig uplink via the 2 1 gig fiber links. Is this just a matter of setting u...
Company wants to move all DHCP for computers and voice to a new Windows DHCP server from Linux. Right now the DHCP pool at headquarters is 192.168.1.100 - 192.168.1.200 and there are servers on that same subnet. They want to use 192.168.3.0/24 as a n...
I just started working for a company that has no documentation for the network. What i am trying to do is setup 7925 wireless phone and the wireless system uses a 5508. The WLAN for the phones has a pre shared key but it just shows 3 asterisks. I can...
Let's try this again. Just lost 10 minutes of typing.Richard, yes, WOL is working fine. While grabbing the config info I found that "access-list 11 permit 192.168.10.241" was missing which I may have removed after testing. I added it and it appears t...
In viewing the WLAN security it is WPA+WPA2. Do I have any other options other than changing it and going to each phone currently using it to put in the new PSK?
I have:aaa new-modelaaa authentication login default group radius localDo I just addaaa authentication login default localor does "default" create a conflict?
