Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Friends,
Please advice on below.
We have a customer who has taken 100 Meg internet line.
There is a managed switch (l2) in customer location, switch details are.
WS-C2960S-24TS-S
(C2960S-UNIVERSALK9-M), Version 12.2(55)SE5, RELEASE SOFTWARE (fc1)
...
Hi All,
Can you please advice me on below?
There is a site to site VPN between C891F-K9 router and ASA5545 which goes down once in some days (say 12 or 15 days). No one touches either the router or firewall by any means, it just goes down not sure w...
HI All,
Can you please advice me on below?
We have a WS-C3850-24XS switch which comes with 24 10G optical ports. As we needed GIG copper ports, have ordered extra Network Module C3850-NM-8-10G which supports either 8 GIG ports or 8 10G ports. Initia...
Hi,
Please help me with the process/commands to load an ios into 6880-X switch from rommon mode. This is a brand new switch.
I have respective ios in the USB
thanks,
Nagasheshu.
Hi All,
Do we have a equivalent command in nx-os (7000 series) for ip tcp adjust-mss or an alternate way?
Please advice.
Thanks in advance,
Nagasheshu.
Hi Matthew,
That should not happen if you have configured WAN routing protocols properly. As soon as the WAN on primary goes down at LAN B, LAB a starts learning routes for LAN B through back up router. Therefore, the communication should be successf...
ok you can one thing in this case.
Under same router LAN interface (where you are running HSRP for MPLS), you can write another HSRP with different group number. Then write new Track to track internet WAN connection and call this track in new HSRP ...
