Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have my HQ site that has a Cisco ASA 5508 and it is terminating my VPN from my remote sites. The remote sites have Meraki Firewalls in place. When the site has a circuit issue with the provider and it comes back up it will build the tunnel with no ...
Hello,
We are looking at implementing a conference bridge in our environment but there is a request for it to be able to dial a predefined set of numbers when a users dials a specific conference number. We are currently running Cisco Call Manger as o...
I have (2) HP 8206's that I am using as my core switches, (2) 4451 Cisco ISR's that I am using as my Core Routers. They are connected with Port Channels and LACP Distributed Trunking for full redundancy. This configuration has been working fine for t...
Good evening,
I started at a place that installed Cisco Meeting Place many years ago. Yesterday the Cisco 2821 that was terminating the T1's had a hardware failure. We have received a replacement but they never saved the configuration to memory so th...
I currently have a Cisco 2821 that is terminating 3 T1 lines for my Cisco Conference Bridge. I was not around when this was configured and was tasked with replacing it with a new Cisco router since the 2821 will be EOL in October. What do I need to v...
I have glanced over this product but now with a second opinion I will contact out account rep and ask for additional information and pricing. Thank you for your assistance.
I have limited the connection to only one path between the Core Router and Core Switch. No change in the connectivity. Is there a debug that I can turn on to see what the router is doing with packets destined or sourced from a specific IP? Thanks.
