Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi experts,We will be doing ACI upgrade from 3.2(5e) to 4.2(7f)our ACI fabric have around 12k endpoints learned in EPGs associated with L2 BDs (unicast routing disabled, ARP flooding enabled, gateway not on ACI) as well as other EPGs associated with ...
Hi,I am in the process of building an ACI simulator in our lab environment.The ACI simulator VM is deployed on an ESXi host which is connected to an actual physical ACI fabricDuring the initial setup, I configured IPv6 OOB mgmt IP address on the ACI ...
Hi ACI Gurus, I want to understand how to check the TCAM utilization on ACI Leaf switch.I found below information but not able to correlate altogether. The following link shows that for Nexus 9300 switch the default TCAM allocation, SPAN is assigned ...
Hi,I want to know what steps can be followed for change implementations in Cisco ACI1) to capture the pre and post change logsI am following - configuration snapshot, screenshot of the System health and APIC health, screenshot of the Tenent faults2) ...
Hi,
I am able to execute this script, meaning i am getting the expected output, however wondering why i am getting the error regarding "websocket", what does it mean ?
(py3venv) C:\Users\Nilesh\Documents\aci_auto\acitoolkit\samples>python aci-show-...
@egoepfert , Thank you for your response. Policy CAM is not same as TCAM per the blog on the URL mentioned below.https://unofficialaciguide.com/2021/01/06/understanding-aci-tcam-utilization-optimization/ My Aim to identify the TCAM space is to check ...
Thanks for confirming about the endpoint DB not maintained across reboot.We have planned upgraded of switches in multiple odd even groups spread across one week per fabric. I did considered state checker app, but I found it very slow (unresponsive af...
I think this is expected, when the peer is down.In my case I was able to see the BGP neighbor via CLI in idle state for sometime immediately after I pushed the configuration. And the entries got cleared after few minutes.the neighbor entry should sho...
The following query will give EPG static bindings for all paths VPC as well as for non-VPChttps://{{apic}}/api/class/fvRsPathAtt.json?rsp-subtree=full&rsp-prop-include=config-only if you have used some naming convention for VPC policy groups, like if...
