About alberto-pesce

alberto-pesce · 10-09-2018

Hi all, I would update my ASA 5505 from Cisco Adaptive Security Appliance Software Version 8.2(1) Device Manager Version 6.2(1) to Cisco Adaptive Security Appliance Software Version 8.4(2) Device Manager Version 6.4(5) Do you think is needed to...

alberto-pesce · 08-01-2018

Hi all, I've a question, after the command clear config all set using a SSH , as aspect all the connection drop but what happen after a power reboot of the firewall? The previous configuration save will be load again or the firewall still in a not ...

alberto-pesce · 02-15-2016

Hi all, I would like implement a configuration based on (Cisco 2800, ios 12.4(13r)T) in order to have clients inside that connect a server outside using a single outside IP address. Best Regards

alberto-pesce · 12-16-2015

Hi all, I need to reset a firewall (ASA 5505) located somewhere , I would like to implement a remote reset using SSH in order to clean the configuration and with all port in shutdown... in other way with only a physical access available (using CONSO...

alberto-pesce · 11-02-2015

Hi, does the CISCO IE 4000, with recent IOS, support the VLAN rate limit ? If it possible what are the commands? Thanks in advance. Best Regards

alberto-pesce · 08-01-2018

thank's a lot

alberto-pesce · 02-24-2016

Hi Tom, I'm sorry but my question was only for investigation about the device's features. Best Regards

alberto-pesce · 02-16-2016

Ok, with the configuration below it is working :-) how can I create a pool with single IP address instead of 4? interface FastEthernet0/0 ip address 192.168.0.254 255.255.255.0 ip nat inside!interface FastEthernet0/1 ip address 172.16.0.254 255.255....

alberto-pesce · 02-15-2016

Sorry for the puzzle. My intent it is to find a workaround for Server that accept only one client connection per each. I'm trying to forge multiple request as coming form single IP address, as reported in the scenario attached on my first post. It i...

alberto-pesce · 02-15-2016

Hi, do you think that I have to implement also some access-list? My scope it is to forge client's request to the server as a Unique IP address (due to the restriction on server 172.16.0.250) Best Regards interface FastEthernet0/0 ip address 192.16...

Member Since	‎01-20-2011 12:04 AM
Date Last Visited	‎10-12-2018 12:22 AM
Posts	28

User Statistics

User Activity

Update ASA 5505 from 8.2(1) to 8.4(2)

ASA 5505 8.2 clear config all

NAT many-to-one

ASA 5505 Remote reste configuration all disabled

IE 4000 and rate limiting

Re: ASA 5505 8.2 clear config all

Hi Tom,

Ok, with the configuration

Sorry for the puzzle.

Hi,