Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,The following simple configuration run flawlessly on my C1111-8P and IOS XE 16. As you can see, I have a trunk ethernet port connected to a switch feeding my router with two VLANs (1 and 2). And both of my VLANS are bridged on two separate B...
Hello guys,The following config is working flawlessly in a C886VA but in a C1111-8P and IOS XE 16 (or even 17) I experiencing a very strange issue. My bridged interface (now BDI2) seems that is never executing the authentication commands (authentica...
Hello,I have a simple working IPv6 configuration with stateless autoconfig on Dialer1 and it is working fine. My config is this:!
ipv6 unicast-routing
!
ipv6 dhcp pool BVI1_DHCP
import dns-server
import domain-name
!
interface Dialer1
description...
Hello,I have a simple working IPv6 configuration with stateless autoconfig on Dialer1 and it is working fine. My config is this:!
ipv6 unicast-routing
!
ipv6 dhcp pool BVI1_DHCP
import dns-server
import domain-name
!
interface Dialer1
description...
Hello,I recently bought some 8821 to install them under asterisk 13. I am using the latest SIP firmware 8821.11-0-6-7 and my phones seems they are working as expected without issues while I install one single SIP account per phone. If you try to add ...
First of all make sure that you have created your PJSIP extensions and they have both the same password:username / authID: 111password: Temp123456789username / authID: 112password: Temp123456789 Then change your usernames in /etc/asterisk/pjsip_custo...
Hello,You need to cook your SEP{mac}.cnf.xml as well and declare there your accounts according my example before. Keep in your mind that SEP{mac}.cnf.xml should be available via a tftp server so your phone can read it upon boot.
Hello,Did you find this switch somewhere? I have the same issue and I am looking for this old "C&K 30" pcb switch or whole assembly.BTW, From what I understood, its the same assembly and/or switch for all 8800 series. So if you desperately wanna repa...
Hello again,First of all lets make a correction to my previous post (almost 6 months ago). The problem with the registration of multiple SIP accounts (while you use Enterprise firmware) is related ONLY with 8821 and NOT with all 8800 series. I al...
Hello,Two years from my last post in this thread and what I made sure is that no Cisco IP phone (exempt of 3PCC versions) are able to hold more than one line configured out of Cisco Call Manager. As @pieterh wrote before: "PHONE registers itself to ...
