Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have ISR routers (3845 & 2825) with PVDM2 built-in. running MGCP to comunnicate with CCM v4.2.I want to use these DSP in order to use as IOC conference bridge resources and Transcoder.Regards,
Dear all,I need an information due to upgrading CCM from v4.2 to v5.1I have MCS7825-I2. It is applicable for windows OS, or just Linux OS is supported.also i am not sure if IBM server can run Linux.Regards,
Do one thing more, try to telnet the other end router, and ping your LAN (using the extended ping). if it success that mean you have to review the configuration in your side router and check the access list.if it fail, i think the problem is on the t...
HI Scott,I believe that you have to delete or modify any access list or other configuration that is using that Static NAT.or you can use the CLI to do that with NO prefixing it.Regards,
Hi,As i see from the configurations, you need to use the Bandwidth command under the serial interface for both router, clockrate is not related to this issue.second thing, under the ospf proccess in SE2 router,there is no need to command network:netw...
