Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to set up AAA authentication for all routers I manage so that technicians log on to the routers with their Windows usernames and a RADIUS server determines whether or not they have access. The RADIUS servers used in the routers' configura...
Our client connects to our data center via RDP with a public address. They have two different ISPs and traffic is routed over each depending on its destination. Their RDP connections go out WAN1. When they are in their RDP sessions they cannot reach ...
Can someone tell me how applying "ip nat outside" to int f0/1 causes the VPN to fail? The VPN is from 192.168.103.0 network on a remote site to the 10.5.1.0 network on int f0/0. Should I be using IP NAT Service? config is attached
I have an 831 running Version 12.4(19b) IOS. For some reason the ARP table includes every single address visited, whether it is on the LAN or through a VPN or on the internet. I believe this is slowing the performance of the router and might even be ...
I have a router and switch that I am trying to get setup with trunking and VTP. I believe the trunking is working but the output of some show commands makes me think otherwise. VTP is not working at all - both devices are in the same domain, using th...
All of those NAT statements I have in the router work fine from outside of the RDP session. What is the benefit to pointing them to the interface name rather than the interface's IP? Yesterday I tried your suggestion with the 172.18.127.10 NAT and th...
Here is a trace from the router to the RDP server. The router is putting the traffic out the correct interface.gem-nj_gem#traceProtocol [ip]:Target IP address: 63.123.252.123Source address: 172.18.127.1Numeric display [n]:Timeout in seconds [3]:Probe...
