Is it normal for the OSPF routes to be updated in the routing table every 20 sec.,O 10.11.254.80/28 [110/14] via 10.1.131.131, 00:00:09, FastEthernet5/0/0As you can see from the partial ?show IP route?, the route was updated 9 sec ago, it keeps...
In 12.3T Cisco increased the number of BGP equal path links from 6 to 16. Does any one knows if they increased for the OSPF and static routes as well. Is there any supporting document on Cisco web sites?Thanks in advance..
I have two servers connected to a 3550 and I want separate these two servers at L2 and make them communicate at L3. So I configured both ports with ?switchport protected?, and I connected the switch to a 2800 router, where I have interface VLAN confi...
I have two servers, 10.1.1.21 and 10.1.1.24/24, both are connected to L2 6500 switches on the same vlan, and the interface VLAN is defined on a router connected to the 6500 switch (VLAN IP is 10.1.1.100/24), when these two servers talk with each othe...
I have a MGX ATM switch with RPM, on the RPM, the switches subinterfaces (Interface switch 1.1) are configured as multipoint. I was told that on the MGX you have to use PBR to force the traffic into a specific PVC (logical) and you can not relay on t...
I searched Cisco web site and can not find it this info, I just need to know which IOS I need to have in order to allow 12 equal path load sharing for either static or OSPF.
We can not change the IP's on the servers. We are not allowed to do that. The question I have, in the protected vlan's setup, why should the router answer the arp request from server1 on behalf of server2, even though the router has no idea about the...
on the 3550,interfast 0/1 (connected to server1)switchport mode accessswitchport access vlan 200switchport protected!Same config on interface 0/2 (connected to server2)!Interface fast0/4 (to the 2800)switchport trunk encapsulation dot1qswitchport mod...
