Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We currently have an SSID that is used for Video calls using iPad devices high density environment. I noticed today after a health check, that our Video SSID is using the Radio Policy "802.11a Only". I'm convinced this is the reason for our qua...
Hello,I work for a company where i need to stage 9120 access points and provision them manually with a AP Name and Primary controller before i ship them out. After issuing the commands it seems the AP just ignores them and doesn't update the AP name ...
Hello,I'm not sure why SSH is still being passed to the control plane. We have some automation issues we're trying to work out, but i'm trying to incorporate a temporary solution.The goal here is to limit the amount of SSH traffic. It appears that SS...
Hello,I'm trying to figure out why Avaya Phones and PC's are showing up as both statically and dynamically learned. We do not have any mac addresses statically configured. Here is the output of a few ports.Cisco9300# show mac address-table int Gi8/0/...
Hello,I'm seeking assistance with a situation involving two companies operating under the same umbrella, each with their own 9800 Wireless LAN Controllers (WLCs) and over 400 Access Points (APs) connected. Currently, our Rogue AP list is extensive, w...
Its working now!I may need to fine tune the exceed traffic.Class-map: SSH-Class (match-any)0 packets, 0 bytes5 minute offered rate 0000 bps, drop rate 0000 bpsMatch: access-group name SSH-ACLpolice:rate 8000 bps, burst 1500 bytesconformed 86622 bytes...
Here is how our ports are configured.Cisco9300#show run int gigabitEthernet 4/0/19Building configuration...Current configuration : 384 bytes!interface GigabitEthernet4/0/19switchport access vlan 4023switchport mode accessswitchport nonegotiateswitchp...
