Hello.
i have a question about EIGRP.
there are two EIGRP processes that run and two equal paths are learned, one by each EIGRP process. which routes get installed to routing table? how can i control that process?
Aleksey.
Hello everyone.
I have two ISP in branch office. Both connected through Cisco 881 router.I looking config example which allow connect via SSH through primary and second ISP at the same time. i wanna ICMP and telnet too.
i think it is must be PBR. May...
Hello Giuseppe!
Thanks for help! your solution with AD change working normaly. But we will change design to use single AS.
router eigrp 10distance eigrp 190 170
The route that is installed into the EIGRP topology database first gets placed into the routing table.
P.S. lowest AS number have effect also in some IOS version
thanx for reply
there are Cisco FAQ about this issue. but this not what i want.
http://www.cisco.com/c/en/us/support/docs/ip/enhanced-interior-gateway-routing-protocol-eigrp/13681-eigrpfaq.html#eight2
---
Q. If there are two EIGRP processes that run ...
for example
have two AS on same router.
from AS one (1) learned 192.168.1.0/24, FD is 1000 via 192.168.2.1from AS two (2) learned 192.168.1.0/24, FD is 1000 via 192.168.3.1
have result: now AS one (1) is successor alwaysi wanna get next result: AS tw...
