Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi serniors,I have Lan/Wan setup in my office with Cisco routers & switches. OSPF is running on serial as well as multiaccess network. Yesterday I noticed that 2 routers changed adjacency from FULL/DROTHER to 2WAY/DROTHER. Network is running fine wit...
Hi guys,Ok , I am studying little bit of switching technology for my day to day job requirement. May be following are very basic questions for you guys but really difficult to understand for me.How one can fine the MAC address of a cisco switch. For ...
Hi Seniors,I understand that vlan's can be created on cisco switches but last day I was looking on the configuration of my office cisco router and I saw configuration on vlans interfaces. I ran the command "sh int vlan20" and I saw the interface. My ...
Hi seniors,,While studying CCNA, the following question about trunking is in my mind but not clear,,,--> Can we define two interfaces as a trunk ?e.g in a lab there are 3 switches , sw1. sw2. sw3. Only sw1 is in distribution layer while sw2 and sw3 a...
Hi All,For further study of CCNA and labs I purchased 1760 router. Otherwise working OK but it is not saving running configuration. After changing the running config , I issue the command -->Copy running-config startup-config. It saves. I switch off ...
hiNothing was added in that particular network. In that particular network there are 8 routers on the multiaccess network and definately on some segments there are DR and on the other therer are BDR. Routers have FULL/DR and FULL/BDR adjacency on oth...
Yes Kevin , it is good explaination but when we run "show version" we see the MAC address. So is this MAC address the Bridge ID that is used in spanning-tree for the selection of root bridge ?Thanks.
Thanks Norman for your reply.The document you refered is much technicial. I only need the answer of one question.How to find the MAC address of a cisco switch ? "sh mac address-table" shows mac addresses. "sh ver" show mac address. What is the actual...
Thanks Peter for reply ,,Meanwhile I noticed that the value for config-register is 0x2142 instead of 0x2102. I changed it , rebooted and now it is starting from saved configuration.Best regards,Tahir.
