Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Are there anybody here that have suceeded in upgrading a 1231G with the firmware from the controller version 4.1.185 (ap sw 12.4(3g)ja2) ????Best regards Henrik
Help, i hope any body can help, the beta client for vista seems to be missing the stateful firewall. Has anybody got it to work where the firewall required flag is set ??/Henrik
Hi I have 2 asa 5510 which should be running active/standby failover.When i turn on the standby unit, the primary says "replicating with mate" and then "replicated with mate" then the standby unit reboots, starts replicating again and again and again...
HiI have a problem I need to know if it is possible to access the internet throug a vpn tunnel without having enabled splittunneling, im running 12.3.14T. The router i located directly on the internet.Best regds Henrik
Hi. I also have this problem, where the fiber link, goes down for 3 sec, and the other switch doesnt notice it, like its happening inside ios or inside module.Im using 3560 switches with this ios : :c3560-ipbase-mz.122-35.SE5/c3560-ipbase-mz.122-35.S...
Hi you have misunderstood the ?. Our 1231 ap's have been operating as lwapp for the last 4 months, but due to problems with roaming between intermec handhelds, we need to lift our controllers to ver 4.1.185, and it seems that i cant get the 1231 to l...
Have just upgraded my own wcs, and licensing remained due to the backup made before upgrade/reinstall and restore afterwards.Notice that the upgrade is a little complicated.1. backup your wcs2. uninstall your wcs3. install the new version4. restore y...
HiIt is just as simple as making a designated vlan and associate a ssid to that vlan. further more you need an acl eliminating access to your private ip and only allowing the traffic needed for your guests ie. http ftp https./Henrik
