Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, GuysCurrently, I am facing the issue in IPv4 route with an IPv6 next hop in IPv6 BGP.
Topo & Versions:LO:10.99.99.99 <---> FlexVPN HUB (CSR1000v w/fixed IPv6 addr.) <---(IPv6 peering)---> FlexVPN Spoke(ISR4321 w/dynamic IPv6 addr.)--->LO:10....
We are looking for Cisco IPICS system E&M interface to Radio Cable.For Kenwood Radios For Motorola Radios Is there have such for sales. we hope we can buy and used in our Cisco IPICS case. My radio is Kenwood TK3230. Thanks for help.
@Harold Ritter wrote:
RFC5549 is not currently supported in IOS. Without RFC5549 support, the next hop needs to be the same as the configured address family. In your case you need to support both ipv4 and ipv6 through FlexVPN.
Regards,
Hello, Har...
Please try to enable LLDP on Cisco Switch side.
Because of GS105PE using LLDP to exchange port power inline capacity.
I have 3560CX , after enabled LLDP on Cisco switch side, the GS105PE can be running under POE+.
Good Luck to you.
Hi, I downgraded to X8.9.2 and test again, it did not solved.
I need sometime to research on it.
Recent days, I am trying to upgrade to X8.10.3, the newest version and try.
Sunny
CUCM/CUPIMP 10.5.2
EXP-C/EXP-E X8.10
I am facing the same issue too. Based on my analyze, the Expressway has big change on X8.10.x, It's "MRA Access Control with Authentication path".
By default, When you select MRA, it will enable "UCM/LDAP basi...
