Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 6509E chassis with redundant sup720-3b in each. I am going to dual home my servers and I want to have hsrp between the 6509 for failover in case of a chassis failure. I am looking to use the sup-720 sfp ports for this failover, is this t...
Is there an snmp trap for vlan membership changes on a per port basis.Example:int fa0/4switchport access vlan 5int fa0/4switchport access vlan 7I need to see an snmp trap for this type of change. I not using a VMPS server. I believe the vlan-member...
I am trying to get my Catalyst 3550 to send snmp-traps for vlan-membership changes. I believe I have the correct syntax in the configuration because I can change traps to config and I get the trap messages but not for vlan-membership changes. I hav...
I have an aironet 1252 access point and I have it set up with 3 ssid's which in turn are 3 separate vlans. My question is, can the 1250 supply dhcp to each ssid or only to the native vlan. This access point is going to be connected to a 4507 routin...
We recently install a new clear channel DS3 and have installed an NM-1T# card and everything seems to be okay but I have noticed that some of our ping response times have increased. I have been looking at the dsu bandwidth on some of the sub-interac...
Thanks for the update..... is there any documentation on thie HSRP set up. I have multiple vlans and from what I was reading it was like you have HSRP for each vlan. Obviously i have vtp set up so each 6509 has all the same vlan information. Th...
with over 300 switches nationwide that would not be practical. I was hoping that there was either an snmp trap to inform me that an administrator had made a change or a syslog message. But it doesn't look with that is the case. And even though a m...
Not what I am looking to do. Is there a version that does support what I am looking for. I've been down the mac-notification road and just to much a pain to work with for something this simple.
It is happening because of dot1x. we run multiple vendors equipment across our network and we vlan each vendor into their own vlan. There has to be a way to be notified when a port on a switch is changed from one vlan to another
