Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was wondering if it is possible to replace the ACI leaf with a different model, I'm very familiar with actual procedure on how to replace a Leaf switch but my question is if I have two Leafs "Nexus 93180YC-FX" want to replace them with two new Leaf...
Hello Guys,
I don't find any documents from Cisco where it shows how can customers migrate from OTV technology for L2 stretched network to ACI?
I only saw a diagram in Cisco IT design page 13 "attached" but no configurations and no guidelines about...
Hi,We have one WLC 5508 and LAG is enabled on it but when we connect 4 cables to a distribution switch only 3 links are sending and receiving traffic and the 4th one is up with outgoing traffic from the distribution switch to WLC but nothing incoming...
We have a Cisco 4500 switches and some of them is being reloaded without a known reason, Please check the log output and let me know what should be the cause for that ?Note that we have Cisco LMS managing the network switches.************************...
I want to make a pin code required when someone dials 9 or is trying to get direct line ...the phone is already with direct line feature but I want authorized users only to log-in and be granted the line otherwise internal calls only and emergency ar...
Thanks @Robert Burns for sure that makes sense to have the same interface IDs as most likely it is 1:1 When you say same generation that means FX goes with FX .. EX goes with EX etc so it does not matter if FX goes to FX2, Correct?
Hi, I had the same issue and got it to work by re-downloading the patch 5 file once again from Cisco.com ... it could be the MD5 hash got corrupted during your download.
https://www.cisco.com/c/en/us/support/cloud-systems-management/application-policy-infrastructure-controller-apic/tsd-products-support-series-home.htmlThis is should be your home page for ACI ... under Configuration Guides then Verified Scalability
It depends on your ACI software version but currently it is 20 FEXs Verified Scalability Guide for Cisco APIC, Release 4.1(1): https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/4-x/verified-scalability/Cisco-ACI-Verified-Scalabili...
Yes we have two OTV sites this is given, you normally use OTV between at least two sites and we have ACI in both locations as Multipod so my concern is STP loops when you start using the same VLANs on ACI in both locations and extend the EPG out for ...
