Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have nexus 9380 pre-configured with monitor session 1 and 2 for SPAN.Session 1 shows source as all port channels destination interface eth1/2Session 2 has source all vlans > destination interface eth1/20Now when am creating a session 3 and ad...
Hi guys,Recently i have replaced a secondary unit of the cluster firewall a-p mode fortinet firewall, which was integrated with cisco ise as Radius server for AAA.Now after replacing i lost ise contact with both fgt and am unable to login with AD cre...
We have a fortigate firewall which has 2 ports connected to cisco catalyst switch as PO.2 ports connected to 2 different cisco nexus 9300 sw2 ports to cisco 9200 switch.Now, we got a new firewall, as soon as we unplugged the cables and connected to n...
We are seeing switch logs as same mac xxxx:0111 is being learned on two access interfaces on the same switch.now after investigation we found the red team was performing spoofing of mac address and their device they applied the mac address of one our...
Hi,we have a collapse architecture, wherein our core sw 9407 acting as a layer-2 and the gateway is our firewall.we have a requirement to control same vlan traffic to block, is it possible to create a layer-2 ACL or something in the Access layer swit...
The configuration is :Session 1 shows as localsource vlan alldestination port-channel 30, 40,50 (each po has interfaces with in even the unused ports like eth1/30)Under the Eth1/30 interface configuration as follows:config# int eth1/30 switc...
Actually, the port eth1/30 is not actually in any port channel, it is an unused port, however, when i do > show monitor session alI see Session 1 is configured with all port channels and ports(which includes unused ports) as Source, how can i remove ...
@balajiI tried the above but it give the same Error: saying the eth1/30 is used in other source port-channel.Since there are existing 2 Monitor sessions which are configured with source as all port channel and other session with source as all vlans.H...
