I'm looking at using the IOS Firewall feature set with stateful failover between two 2900 series routers. I have been working with a configuration that involves the "inside" being WAN interfaces on two different subnets and the "outside" being two L...
I'm trying to see if its possible to use ACS 5 patch 8 to authenticate WCS.Looking at the ACS 5.0 gui I'm looking at where you would enter the tacacs+ or radius custom attributes. From doing some configuration it would seem that the tacacs+ custom a...
Is it possible to answer call waiting during an active call on an FXO port from an IP phone? I have been searching but not found anyone with examples on how to do this. Any help would be greatly appreciated.Aaron
We have a CallManager6 cluster that is licensed for 2 call processing nodes and also DLUs for phones.I'm looking to upgrade to CCM7. All of our servers are MCS-7825-I1-IPC1. Looking at the price list it looks like all I need is CM7.0-U-K9-7825. Wi...
I've been looking over the docs and it looks like the 881 ISR is currently only supported on CUCM7. Has anyone configured the FXO port for use on another version of CUCM? If so how did you so so?Thanks,Aaron
I have not heard of this product being released but looking at the list above you will notice the 4948E has SFP+ ports. I would say this is a newly released switch. It may not be available on the product site yet but is on the price list. Aaron
I have been using that link for the configuration. In looking at the guide it's wanting HSRP on both sides(inside and outside). What I was curious was if anyone has done something similar to the diagram below. I have also attached the diagram in c...
