Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
i have question regarding SD-WAN design, for the HQ router showing below in the picture should it be working as normal routers to connect the sites or have to be vEdge VPN0/VPN512
consideration the HQ right now is only connecting to other sites ...
greeting after upgrading the RSP from 440 to 880 and rebooting the device i had an issue where one of MPA started showing disabled A9K-MPA-4X10GE DISABLED NPWR,NSHUT,MON which was working normally before the reboot. after changing the MPA to another ...
dears i have installed 2 RSP880 as active/standby. but while doing #show redundancy i seeNode 0/RSP0/CPU0 is in ACTIVE roleNode Redundancy Partner (0/RSP1/CPU0) is in STANDBY roleStandby node in 0/RSP1/CPU0 is readyStandby node in 0/RSP1/CPU0 is NSR-...
hello Experties We have ASR9k10 with single RSP440 installed as active the plane to upgrade it to RSP880 after shutting down the device the replace it with single RSP880 and booting up it got only rebooting again and againcopy of what showing in cons...
Hi Adrian
thanks for your reply
my question more related to design and best practice for HQ routers from SD-WAN perspective
since all the controllers will be on-Prem, should it be as a normal router or to change to SD-WAN fabric (Pros/Cons)
thanks so this is normal what about the switchover procedure is it safe to proceed? is there a command line or just pulling the active RSP? and if yes for pulling is there minimum time to insert it back?
hello tkarnaniNode 0/RSP0/CPU0 is in ACTIVE roleNode Redundancy Partner (0/RSP1/CPU0) is in STANDBY roleStandby node in 0/RSP1/CPU0 is readyStandby node in 0/RSP1/CPU0 is NSR-not-configuredNode 0/RSP0/CPU0 is in process group PRIMARY roleProcess Redu...
