Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all
Hope someone can answer the below for me.
Is a policy-map mandatory for dot1x to work when using IBNS 2.0 with ISE ?
I have two ports on a switch configured for dot1x. Out of the two, one is configured without any policy map and the other h...
Hi there
I need to get the following scenario working and hope someone can help.
I have two sites (A -1.1.1.1 and B-2.2.2.2). both have Cisco ASAs as their perimeter firewalls. They have site to site VPN configured between them.
Site B has a web...
Hi there
I have a requirement to configure a site-to-site VPN on a ASA 5506 which is configured as a PPPoE client on its outside interface. I'm looking for any documentation or advice on on how the VPN section should be configured. Currently I have ...
Hi there I'm not even sure if this is possible but hope someone can help me out if it is . What I would like to do:On a ASA 5505 (9.2(1)), i would like to do a shut and no shut of the outside interface every time out going traffic flow stops. so i...
Hi I'm trying to configure "IP PIM SPARSE-MODE" command on a vlan interface on a 3560E switch but it doesn't give me the option to do this. The only option available is ip pim passive. What would cause this ? On the same switch a physical interface i...
Thanks Rob. The prescriptive deployment guide is what I used for my deployment and is really good. And the following Cisco live session is also a good deep dive into IBNS 2.0.
https://www.ciscolive.com/c/dam/r/ciscolive/global-event/docs/2025/pdf/BRK...
sorry had a typo in the end ... it should have been... " So it seems that without a policy map, the switch port doesn’t try to authenticate as I don’t see any logs on ISE for it. Is this by design or have a completely missed something simple here?
