Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI planning an implementation with CUCM Cluster, Right now I have 4 offices with, 2 offices CUCM 4.1 and Unity 4.0, rest 2 CME. Each office has separte PSTN lines and geteways, In the main office We'll have a cluster with IPCC 7.0, but the main d...
HelloI'm trying to connect Switch 3560 to NTP Server based on Linux, the NTP is working fine but the switch is sync with the Server: address ref clock st when poll reach delay offset disp*~10.0.0.70 208.53.158.34 3 ...
HelloI wonder how do I configure an PSTN incoming call for an extention in the UC to foward that call to the reception number, but ONLY the PSTN calls?Thanks
HelloI have an UC 560 with 100 Ip phones with 2 T1 lines, and sometimes a couple phones lost communicactions with the UC, and for the phone start working again you need to unplug the phone, We used to have an CCM 4.1 and didn't have this issues, for ...
Thanks for the answer.I'm going with the Option 1, migrate all the sites to the new cluster, but my main concernt is how to handle the incoming calls issue using the new cluster.
Thanks for your answersBut if they're synchronized why is getting the wrong time, also I put the same time zone of the sever, and in the serve I could see the switch associated with the server.But in the CUCM sever works fineAny suggestion ThanksSent...
