Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there, I would like to ask if there has an opportunity to convert VoIP to Analog telephone exchange, what equipment do I need in order to achieve that (hardware and software)?thank you very much indeed for your helpBest Regards
HI guys, I have an issue with my cisco 851W routerwhen I try to configure fast ethernet port , I keep getting an error: IP addresses may not be configured on L2 linksaccording information from the forum I have to :""""""""""""""""""""""""""""""""""""...
thank you very much to all of you for your prompt responds, the idea is that I have an analog exchange central that is valued to approx. 1400$ and I would like to use it, so with this ATA187 I should achieve the using of my analog phones, am I right?...
thank you very much indeed for your fast replythe configuration should be: R1#conf tR1(config)#int vlan 1 R1(config-if)#ip address 192.168.66.101 255.255.255.0R1(config)#interface fastEthernet 0
R1(config-if)#switchport mode access
R1(config-if)#s...
