Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Could someone confirm if there is an equivalency of the router's exclamation mark on WLC CLI to put comments on a config file?Thanks a lot in advance. Marc
Hi,I've followed a process to reset the password on a Catalyst 4948 (http://www.cisco.com/en/US/products/hw/switches/ps663/products_password_recovery09186a00800945f7.shtml) but now the switch doean't want to start.The message is : *******************...
Hi,Hourreey !!!It is impossible to manually set a value to the register. The only way is to use the command confreg.So, I didn't see the statement " 1 = the first file from internal flash device" but with your help, it works fine now.Many thanks for ...
Hi,Thanks for your help but these commands aren't available.The available choices are : alias set and display aliases command boot boot up an external process clear clear configurations, use 'clear help' for mo...
