Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a server with two Intel x552 SFP+ interfaces. These contain 2 Intel 1Gb/10Gb dual speed SFPs (Intel official). The server is running ESX and it states that the interfaces are connected, running 1Gb. [root@esx05:~] esxcli network nic get -n...
Hi, We use the private space 10.0.0.0/8 for our corporate inside resources. One of our office has 10.29.0.0/16.We created a Site-2-site connection between 2 ASA between corporate network and office. This VPN works fine. From our corporate network we ...
Hello,we're using an IronPort S170 WSA. Downloading big .iso (maybe other files, too) files fails. As far as I can find out, files of 2300MB or less can be downloaded, files of 3300MB or bigger fail to download (I haven't been able to try files with ...
Maybe a bit late. But today I ran into the same issue, when trying to run vWLC on VMware Workstation. v16 in this case.I could ping the management interface on my host, but could not connect to it.My fix: - deploy ova- after deployment: > assign ethe...
Hi Reza, thanks for reply. What I have tried during my investigation: - Other SFP (GLC-SX-MMD) on Cisco side- Other SFP (Intel certified) on Intel NIC side- GLC-SX-MMD in Intel adapter (it is stated on various sites this one is also accepted by the I...
Files are not blocked immediately. The page tries to download the file for a while. Then, after a minute or so, the proxy page appears.About authentication: the access policy is configured not to require authentication.I suspect a built-in limit. But...
Sorry for my misunderstanding. I was not aware of the fact that the NFR installation differs from the ISO install.I don't think I can be of any help.Maybe, based on the installation process of other cisco software, it could be:L/P: cisco/ciscoL/P: Ci...
The mentioned username/password combination is for the web interface only. The username/password for the CLI (RedHat as you call it) is provided during install. There is no default here.
