Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Imagine a situation in which a EBGP session is setup between two routers A and B.Router A advertises routes that are configured using the 'redistribute static' statement AND defined in an ACL that is called upon using a route-map.In this situation I ...
Is it possible to make sure the top Supervisor Engine (1a in my case) is the Active module after a box reload always?The box is running in Native mode here.
At a AS5300 when configuring the command 'no snmp trap link-status' underneith the serial 0/0:15 or dialer interface does not prevent traps from being send every time a RAS user dials in.To my believe this is caused by the fact that this command is n...
When trying to connect a router which gets its IP address from the provider I dial in to, I want to connect to a VPN3000.However when configuring LAN-to-LAN the VPN3000 expects me to have a fixed IP address at the router.It uses this IP address as gr...
When trying to connect a router which gets its IP address from the provider I dial in to, I want to connect to a VPN3000.However when configuring LAN-to-LAN the VPN3000 expects me to have a fixed IP address at the router.It uses this IP address as gr...
Issue solved here! Replaced AP MR18 which was suspected by Meraki support engineer.Then still issues popped-up. I started searching specifically for WiFi issues and MacBook and found the issue. Connecting certain HDMI (or other peripherals) can cause...
Same issue here. Just upgraded to release candidate 37.1.7.1 and checking if we speak if issues are solved. The issue only relates to my MacBook, iPhone wifi connectivity does not seem to suffer when experiencing MacBook connectivity issues. For now ...
After studying your drawing I found my previous reply still is ok. Another option could of course be to have a new separate interface configured at your Firewall into the new subnet. Also make sure you configure routing as needed if you do not use NA...
