Hi guys,
I am trying to add my WAPs to the Cisco Prime maps.
I was able to add the WLC but when i added my access points (2702i) they show as "un-managed" and a yellow triangle with status - "SNMP failure: Failed to perform the SNMP get". As i under...
Good day,
I am looking for a way, CLI or GUI to change the syslog port from 514 to 1514 or other as our log server is not able to listen on 514. I've looked in both but do not see any place to change this.
Any ideas would be welcomed.
Thanks
MP
Hi guys, I'm trying to set up {as per our phone guys} a phone server in the DMZ. The requirement is to have a public address (from our outside scope /29) assigned to this server and it has to be public on the internet to sync with an external system....
Hey guys,Can a profile be created so that when the user connects instead of seeing a drop down list to choose a profile they are prompted to a specific profile with no ability to choose?Thanks MP
(Jan 2020) There were some issues firing the command but after a few tries i got it to work as follows: ovftool --acceptAllEulas -dm=thin --name=test-ise --datastore=ds-esxi01 "K:\tmp\ISE-2.2.0.470-virtual-200GB-SNS3595.ova" vi://xxxxadm:<password>@1...
Hi,
I noticed something similar the other day when i was running wireshark where my device kept sending DHCP requests though it had an IP and the DHCP server lease is 1day.
Here is a link that references it (partially) and might be useful.
https://mr...
Hi guys,
When i added my access points they come back as "un-managed" and a yellow triangle with status - "SNMP failure: Failed to perform the SNMP get". As i understand it SNMP is disabled on LAPs controlled by a WLC.
Any help would be great as it...
Hi Ric,
I did a lot of digging but didn't see any hint on how to change this in the WLC. Its a funky Syslog server already listening on port 514 for logs from somewhere else that also doesn't have the ability to edit their default port.
Cheers
MP
