Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have created an ipsec vpn for the cisco vpn client application on an IOS 15.1 router. Most everything seems to be configured as it should, the clients can connect, authenticate and are assigned an IP address from the configured VPN pool. However, ...
I'm about to purchase a C1841 router that will need to allow people with the Cisco VPN client (and perhaps a remote PIX at a later date) to connect to our LAN.From what I've been able to find on the Cisco site the HSEC enables a hardware VPN module, ...
I'm trying to route between 2 VLANs using a C1760 with a WIC-4ESW installed.When I try to create a subinterface I get the following error:Router(config)#interface fastEthernet 0/2.1 ^% Invalid input detected at '^' marker.(It ...
I've just built some CCM 4.1(2) servers and plan on rebuilding the phone system from scratch to take advantage of the new features in 4.x, and also because the system is in a right mess at the moment.I understand "Cisco CallManager Fundamentals: A Ci...
We have a block of IP addresses and have assigned various internet-facing servers public addresses using the following (on a 1760):ip nat inside source static tcp i.i.i.i port e.e.e.e port extendableIncoming and outgoing mail works just fine until th...
Having the same issue. I hadn't noticed (ublock) but it was brought to my attention today. I'd rather not unblock the entire Advertising category to fix this. Hoping this is a temporary "oopsie".
I'm still not sure why it seems to make no difference which interface I use in the Virtual Template's ip unnumbered statement. I figured it should be on the "inside" interface but somewhat alarmingly it doesn't seem to matter which interface is chos...
I just tried reversing the order but no change in behaviour. Incidentally, I am occasionally getting the following in the router console:
% 192.168.50.0 overlaps with Virtual-Template2
I changed the Virtual-Template interface definition from this
in...
Is this the section you mean - do I have something missing here?
crypto isakmp client configuration group CORP-VPN
key key
dns 10.10.10.31
pool VPN-pool
acl 120
max-users 5
crypto isakmp profile vpn-ike-profile-1
match identity group CORP-VPN...
