Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a problem with my MGCP controlled 3945 PSTN Gateway router with IOS 152-4.M5 with card VWIC3-2MFT-T1/E1CUCM Version 9.1.2Everything seems working normally, I can make inbound call from PSTN and reach auto attendant, until I found that there...
I have problem using User tracking utility, I am installed LMS 2.5 under Win 2000 Server SP4 and my Network using two 6506 and 2 Firewall Blade module.from about 250 hosts detected only 2 host ip address appears and the other blank.before i deploy vl...
Hi Jamie, I did your suggestion, and now I can see calling number on my ipphone when I make inbound call from Pstn. But before the call is answered showing unknown, but after the call answered I can see the actual calling number. Is there anything I ...
I Checked from IOS since I cannot found an endpoint registration for digital/ E1.Following is output from IOS, showing all endpoint ports are registered, and from CUCM shows registered as well (attached)CKRGSRST01#show mgcp endpointInterface E1 0/0/0...
Hi Chris, Thanks for reply
The telco confirmed the E1 is full PRI. When I input command show isdn service :
all ISDN channel is in service.
I just curious what could make the router response with different as negotiated with telco.
Is there somet...
Hi, I got the same problem, and I try to put extra parameter /md5example :verify /md5 flash:/c3750-ipbasek9-mz.122-44.SE2/c3750-ipbasek9-mz.122-44.SE2.binand it's work for me.
For addition after i read user tracking problem thread from Mr.moazzam.ali2.I Found that UT read IP address from Router.And I think that is true because 2 detected hosts is hosts that that remain existing in VLAN in 6500, the other user on other vlan...
