Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am doing QA on an IOS and I need to verify the following:http://www.cisco.com/en/US/products/products_security_advisory09186a008055ef31.shtmlAny help will be appreciated.Tey
I have an non-Cisco L2 switch that needs to connect to a Cat 6509 via etherchannel using LACP. How do I assign a VLAN/dot1q encapsulation on the etherchannel/port-channel on the Cat6509 to identify the VLAN.Here's my config;6509-SW-01#sh run int fa3/...
I am not sure if "service tcp-keepalives-in" generates TCP keepalives for TCP sessions "to" this router anad "service tcp-keepalives-out" commands generates TCP keepalives for TCP session "from" this router. Is this correct?Secondly, if I execute th...
I have a locked-out router on our production network which is not easilly acccessible on another country.I cannot access it anymore probably becuase of all the VTY terminal has locked out. I know that exec-timeout should have been implemented but I j...
I was just hoping that I do not need to manually clear each hung TCP session if the command applies to already active sessions.I was just wondering though how much network overhead does it introduce? I notice the Cisco keepalives are sent every 60 se...
"priority" command is used for Low Latency Queueing (LLQ).The BW you specify through this command will provide strict priority queue (always available), usually for delay-sensitive data like voice."bandwidth" command is used for Class Based Weighted ...
