Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone tell me if there is any major difference between SDH & SONET framing . Also any significant risk to configure the Router framing as SONET over an SDH Network ?? Thanks
Can any one Please asssit :I've got a POS link on a 7609 Flexwan Module connecting via a Sonet Network connecting to a remote 12410 GSR.Problem is: i have configured both ends to clock from Line but the OSR keeps reverting back to internal.with the s...
Can any one Please asssit : I've got a POS link on a 7609 Flexwan Module connecting via a Sonet Network connecting to a 12410 GSR. Problem is: i have configured both ends to clock from Line but the OSR keeps reverting back to internal. with the show ...
Guys ..need help. Got an intermittent spanning Tree problem i cant seem to be able to trace. Keep seeing errors of Duplicate Mac address via HSRP interfaces on only two vlans. Scenario : Two Cisco 7609 in HSRP pair, down stream trunks to Nokia ESB Sw...
Dear all . Urgent assistance needed: Scenario:Router currently experiencing high cpu utilization. On examining ospf , seems to be doing excessive spf calculation.Question:1. How can i determine the cause of the high SPF calculation2. What are the rec...
Hi Thanks . I actually digged up a command " fos flag s1 ignore " which seems to change the clocking back to line.Apparently on some Cisco IOS , the Router reverts to Internal if it recieves an S1 bit ??? Question is : is it safe to ignore the S1 Bit...
Hi Swaroop,I have two PE routers in the same sites with uplinks to different P Nodes. The PE Nodes run vrrp on the LAN interface for the various LAN Based CE devices. However , if one P-PE links fails , traffic is not routed via the second PE .Is it ...
Hi Tdrais, Sorted , your response pointed me to the right direction. had mtu mismatch on different ends of the gig connections, hence the high input errors on one side. Regularised the mtu & all came fine thanks
Hi Corey, Had the same problem a few days ago but with a 2511 with octal cables where the lines just want to stay Open. Add the following commands to the Aux Port no exec exec-timeout 0 0 transport input telnet transport output telnetLet me know if t...
