Hi, are these AP ready for sale now, cause I do not find them in the ordering tool?For them to work with 802.11g standard, should I configure the same antenna types used for 1200 series, and is it necessary to place the 6 antennas?
Hi, I am trying to find MTBF for this modular switch but I can not find it on any datasheet from this model, please instruct me how to find it? I need it to demonstrate a customer the advantages of Cisco over 3com, since so far I have found 3com?s 77...
Hi I have a cisco 2611xm with this configuration:2 FastEthernet interfaces (both used)1 Serial interface2 Voice FXS interfacesIs it possible to replace the wic for a card with 1 ethernet port, in such case wich card? The only NM is being ocuppied by ...
I need to change Ciscoworks default thresholds to some devices of my network because it sends too many alerts through a third party software. I have created a new "device group", customized "thresholds", generated an "Alert View", created a new "Eve...
Hi AmitWould it be out of mind, to connect all seven L2 switches with UTP CAT 6E (which can provide Gigabit speed) to my 3560, and get rid of the fiber, since I have 48 10/100/1000 ports available on the 3560 and 1 Gibabit port on the rest of the swi...
Hi thanks for your answer. There is something I forgot to mention. My 7 switches are connected in a bus topology (not in a star since my 3560 only has 2 active SFPs), on a fiber backbone, where 3560 is on one extreme of the bus. Will this create a bo...
Hi, thanks for your answers. I thought about the series 2800 but this branch office serves about 300 users, so I am not sure wheter this model could support this user density, would it? The E1 interface for the data circuit requires to be G.703 and t...
I already know the hardware requirements, what I ask is why is it necessary a dual processor for the enterprise version and if it could work all rigth with a single processor?