Hey Cisco community!
I ran in to a problem when trying to downgrade the software on our new Cisco 3650-48FQM access-switch. The switch is delivered with Denali 16.03.X and we don't want to use that software at this stage.
I tried to install the fol...
Hello!
We are trying to export netflow data from our Cisco 3850-24XS-switches to a lancope flow collector but seem to have some issues with this.
We are using software version 03.07.03E and the following netflow configuration
flow record IXNF01 matc...
Hey!
We are having some issues in our lab environment. I'm out if ideas and want to check if someone else has been experiencing the same issues or if there is a known solution.In this lab environment we have 4x6807XL-chassis and every chassi is equi...
Hello!I hope i placed this discussion in the correct community.I'm currently configuring two asr9001 routers and got a problem when setting up an Etherchannel. I have 2 asr9001 and both have the same configuration, the only difference is the bundle-i...
Hey
Thanks for the fast reply, i had a feeling but wanted to be sure and now I am.
To bad the Denali software feels way to buggy the be deployed in production. We can't use it with our configuration since we ran in to UDLD issues.
I think we might create a new management-VRF and use another interface for management, log and netflow traffic. We have asked Cisco if this restriction will be solved in the future since we would like to use the dedicated mgmt-interface for the above...
http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3850/software/release/3e/release_notes/rn-3dot7e-3850.html#pgfId-1029358
You cannot configure NetFlow export using the Ethernet Management port (g0/0).
Hey!
I have contacted the support with a problem description and a link to this post so i will hopefully get a response soon.
I'm on vacation at the moment but i have collagues that will assist the TAC with further troubleshooting. I will post the re...
We have done a packet capture and no traffic is seen from the management port of the switch on UDP port 2055 or to the collectors destination. So it seems like the switch isn't sending any netflow data at all.
I will be creating a TAC-case about this
