Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We're using a 3rd party splash page for guest access. It's solely to capture name and email address.Part of that configuration from the vendor includes a pre-authentication ACL. When the ACL is applied to the WLAN the client does not get a DHCP addre...
GET/networks/{networkId}/devices/{serial}/lldp_cdpSo, this API requires the parameter 'timespan'.My question is where does the paramter go in the CURL request? I'm using powershell as that's what I know right now. Python is on the list to learn.
We are in a trial with an MX65 and MX100. We want to use the PoE ports on the MX65 for Cisco phones. Neither port 11 or 12 are providing power. I logged in to the local device and both ports are enabled. I've tried different cables and phones as well...
Thanks all for suggestions.I did try using ports 67 and 68 instead and 53. They didn't make a difference. After trying other things, this note from the EWA configuration page was the key."Note: When you add the Portal IPV4 Address information it auto...
I've done this with no issues.Set up the "Non-Meraki VPN peers" on the Meraki. Use the paramters you need. Enable the Meraki subnets you want in the tunnel and save. Then go to the Palo, create an IKE profile that matches the choices from the Meraki....
