Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does any one have a problem with Toshiba portege R100 on connecting to WL Cisco AP-350 it is associated with the AP but does not get IP address, after a few play with network configuration it work ok but next time of reboot the same problem again, al...
I would like to configure a Cisco router as a bootp server to load a digital terminal server with a file "mneng2.sys" from the router flash, instade from a remote bootp server over the wan. need help on configuration does it support?
I would like to configure a Cisco router as a bootp server to load a digital terminal server with a file "mneng2.sys" from the router flash, instade from a remote bootp server over the wan.need help on configuration does it support?israel.berko@hp.co...
Need helpWe have a few mobile PC with intel embedded WL cards.We notice a problem to connect the mobile PC to the WLan , but PC with Cisco Cards are connected with no problemAp softwere 12.02T or 12.01T . the pc is Intel 2100 3B cards with 2100 3B d...
You can use PCMCIA board AIR-LMC352 with to MMCX on it and use a short cable with two connectors MMCX and RP-TNC (AIR-420-1625-0500 ,AIR-ACC1625) or longer cable.And connect it to a directional antenna 13.5dbi that will be very easy to installRegard...
Thanks ,but it is not what I am looking for... I am looking for a bootp configuration that the router will be a bootp server. The image for the terminal server will be on that router flash and when there is a bootp request from the lan interface then...
