Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, after the release of the 1250AP, I was wondering if the 802.11n compatible client adapters were planed or close to release, and if anyone had an information about that.I was also wondering if this AP had any particular CISCO features (like the...
Hello, I am stuck on an NAT for an incoming connection. On a command like static (outside, inside) interface 192.168.1.3 netmask 255.255.255.255[outside is the name of the outside interface to the DMZ, inside is the name of the inside interface, 192...
Well, this is my first Pix experience, and after reading through the doc, I am still with some questions.In the network diagram I send you, have the pix outside interface (to DMZ) to be announced in a public DNS for me to have access to the internet,...
Hello, did anyone tried to use the command [switchport port-security mac-address n?] on [interface VLAN n?] ? (for example in a 2950).I don't have the material to make that test, and I am not sure if it works or not.Many thanks!
Hello, I am trying to departition my flash mem to be able to upgrade one router (2523=> the router run from flash) to a IOS heavier than just one partition (for now in 11.1 IOS). I guess I could with the "partition flash" command but it ask to erase ...
I am stuck on the same question.(after a ROMMON config-register operation, the output of my router is unreadable. So any comand are unusabe). What was the result of your experimentation? Or does anymone have information about this?:?
Yes indeed, an antenna adapted to your physical situation , a good site survey, cisco material (A.P., adapter and software [if properly configured]) are some of the paths to a better reception.
Well Mattia, indeed that was the line which makes it work. I have to understand a bit further about the process, but indeed even to allow a simple a packet to pass through the pix from out to in, a translation from the destination address inside to t...
