Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Currently, I have a PIX-2-ASA VPN tunnel working with no problems.Here is my issue, I want to know if there is a way to configure one side of the tunnel as a "lower security" interface of sorts. I only want one side to be able to initiate traffic.AC...
I have an 871W ISR Router with the default advanced security image (c871-advsecuirtyk9-mz.124-9.T.bin...as apposed to one step up with the Advanced IP Services image. (which requires 4MB more of flash on the 871 to run).The SDM on the 871 reports QoS...
Could someone simply verify if this is a 64/32 memory setup (64MB DRAM / 32MB Flash). IF not, then what..."show version" output on 1760 Modular Router:---------------------------------------Cisco Internetwork Operating System Software IOS (tm) C1700...
Could someone plaese post a link containing a list of the the various letter identifiers for IOS feature sets and thier corresponding features. I'm having trouble finding one. I keep finding articles explaning the IOS release cycles. Some show exam...
After a client has established a VPN connection to our PIX (using Cisco VPN client), is there a way to limit INCOMING traffic types through access lists?Currently, I use the "sysopt connection permit-ipsec" command in combo with a no-nat acl to permi...
****************************Update to my last response:****************************Actually, that turns out NOT to be what I am looking for. I was a little to hasty in accepting the answer. Maybe I wasn't clear in my question.I was looking for away t...
Awesome!...That sounds exactly like what I'm looking for. I'm not familiar enough with ASA new features as it's the first one I've installed.Another forum on another site suggested policy-NAT...such as NAT'ing all source IPs on local LAN to a single ...
I'm assuming the SDM would support the greyed-out features if the image was Advanced IP. It reports the current image does not support the feature. (Someone with Adv IP may verify it through SDM?)My main conern was over the feature being supported i...
Not sure I'm willing to go as far as deleting flash files at the moment, but it's nice to know it can be done. Thanks for the tip. I'll keep that in my back pocket for future reference if I get one for the lab. The current one will be in use soon-...
Eric,In follow up to my own question and yours, I looked at your link (which I've been over before).Now part of my misunderstanding is probably due to the fact I am fairly new to QoS...so I don't fully understand the minor difference in some of the c...
