Cisco Community
English
Register
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
romccallum
‎08-18-2017
Enthusiast
Recent Badges
Awards
Recent Badges
See all
1 Accepted Solution
5 Accepted Solution
50 Replies
20 Replies
10 Replies
5 Replies
100 Helpful Vote
30 Helpful Vote
10 Helpful Vote
1 Helpful Vote
Stats
Member since ‎01-09-2003
337
Posts
204
Helpful
10
Solutions

Re: CPE Management VRF (one more)

Created by in MPLS
09-16-2008
09-16-2008
np sultan best of luck.

Re: CPE Management VRF (one more)

Created by in MPLS
09-09-2008
09-09-2008
you leak the ip addresses of your servers out of your vrf so for instance route-map then add an ext-...

Re: Multicast SSM question

Created by in MPLS
09-09-2008
09-09-2008
amit i can think of a thousand reasons why this could happen. Can you post actual configs of the PE ...

Re: Cisco 2821 high CPU with Multicast

Created by in Routing
09-09-2008
09-09-2008
so all you are doing is configuring pim? No multicast flows? If you have a flow how much is the pps ...

Re: CPE Management VRF (one more)

Created by in MPLS
09-09-2008
09-09-2008
bang on mate. Once the route is in you shall only be able to ping from PE1's loopback address as thi...

Re: Cisco 2821 high CPU with Multicast

Created by in Routing
09-09-2008
09-09-2008
what is the bandwidth of the stream?

Re: CPE Management VRF (one more)

Created by in MPLS
09-09-2008
09-09-2008
ok so the loopback from CPE 1 is in the management table. Use the same logic on PE2 to bring in the ...

Re: Cisco 2821 high CPU with Multicast

Created by in Routing
09-09-2008
09-09-2008
on your interfaces do you have ip mroute-cache? if not try adding that - also make sure CEF is enabl...

Re: CPE Management VRF (one more)

Created by in MPLS
09-09-2008
09-09-2008
on PE1 there is no bgp to the CPE. On PE2 there IS bgp to the CPE but no route map changing the ext ...

Re: MLPPP over two separate physical cable routes

Created by in MPLS
08-14-2008
08-14-2008
Your only issues mate is with latency. However if the SPs are saying ~1ms then you can always nail t...

Re: Migration from 4 COS to 6 COS

Created by in MPLS
08-14-2008
08-14-2008
tbh i dont really see any major cons moving to a 6 cos model. Lets face it prec 5 down to 0 is a 6 c...

Re: PBR on VRF interface

Created by in MPLS
08-14-2008
08-14-2008
have you tried applying a route map on the vrf interface and setting the next hop to whatever you wa...

Re: Routing public IP's to MPLS VPN

Created by in MPLS
08-14-2008
08-14-2008
as dennis eludes to earlier - look up "how to inject a global route into a vpn". That will give you ...

Re: eigrp or ospf in ce-pe

Created by in MPLS
08-14-2008
08-14-2008
HI mate,OK pitfalls and such are as follows.EIGRP or OSPF - what is the customer happier with and wh...

Re: L3 VPN on MPLS and QoS

Created by in MPLS
03-31-2008
03-31-2008
its been a while but Layer 2 cards are cheap cards and have no smart functionality. I thought pipe m...
Public Statistics
Date Registered ‎01-09-2003 02:05 AM
Date Last Visited ‎08-18-2017 03:53 AM
Total Messages Posted 337
Total Helpful Votes Received 204
Helpful Votes Given To
See all >
Helpful Votes From
See all >