Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am going to evaluate Cisco QoS Policy Manager for Solaris soon. Question though, based on the hardware specs for the Solaris version, it needs some ultrasparc processors. Does this mean it wouldn't work on Solaris for Intel? or what they ga...
Hello Guys,We are trying to replace the IP address of our 7209 IP Phone but it was asking for a password, we tried cisco or 24726 but it wont accept it. No one remembers the password anymore, is there a way to reset this to factory default?Thank you...
Hello!I am running a Cisco Catalyst 3750 with IOS c3750-ipbase-mz.122-25.SEB4.binSince we've deployed these switched on our Metro Ethernet network, we are now needing the capability to police/rate-limit the client's ports.I've done examples on Cisco'...
Hello Guys,I am configuring a dot1q tunnel VPLS since it suited our need for the client's requirements. To my surprise the 48 port tx we are using on our 7600 doesn't support this7609-PPE1(config-if)#switchport mode dot1q-tunnelCommand rejected: Gi2...
Hello All, We have deployed VPN's via ethernet and we integrate that via dot1q VLAN's on a subinterface on a GigEthernet. We then make those a member of a specific vrf forwarding VPN for example. interface GigabitEthernet0/1.101 description VPN-CUST1...
If you're on an ethernet connection, you should be able to do etherchannel but like what the others have said, you're do not have the same speed for each, load-sharing wouldn't be optimal.i'd rather do balancing via BGP by choosing what prefix gets a...
I see, what I am concerned with our implementation right now is it has become too expensive if we're going to use either the 8 port gbic osm or the sup port. i guess we need the 48 port 10/100/1000tx that supports jumbo frames for the dot1q-tunnel
