Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm running into problems upgrading a brand new ATA-186 (supplied with SCCP v3.1.0 code ) to v3.2.3 code. I'm sure I've managed this before, as our existing ones are all running 3.2.3 code.We are running UCM 7.1.3 and the Device default is set for...
Hi,Just getting ready for some heavy VG224 roll-outs, and getting BAT working properly to automate adding the gateways.All is going OK, apart from the minor problem that the directory number is not assigned to the port if the number already exists in...
Hi,We use the 1861 ISRs both with the BRI and FXO options for SRST purposes at remote sites, and they are used as the local gateway for emergency calls, when registered with UCM.They are reasonably cheap and flexible, plus they have the bonus of the ...
Hi,It's very easy to do.Delete the SIP handset from CallManagerAdd the handset back to CallManager as SCCPWait for handset to attempt to register and it will then update it's firmware to SCCPI converted one earlier this week.Cheers,Alistair
A very similar configuration structure to how I configure SRST.Try applying your translation profile to the voice port rather than the incoming dial-peer, as that is the only obvious difference I can see.Cheers,Alistair
Yes, you will need a router with an E1 interface card. We currently have 3x 3825 routers hooking up our Production UC cluster, via iQ3000/VG30Ds, to our legacy PBX network of 22 iSDX systems.The VG30D just performs the protocal conversion to DPNSS.Ch...
