Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have two sites with 2 routers each as follows:site1 - router1 - primary link - router1 - site2site1 - router2 - secondary link - router 2 - site2The ethernet interface for router1 & router 2 are different (different subnet)..I want to implement ...
Hi,Could you please tell me how many channels are supported on one Cisco Aironet 1130AG...I means the numbers of users that could be supported by one Cisco Aironet 1130AG.Thanks in advanceBest RegardsMohamed
Hi Martin,It's gonna be easier if we have one router with two links (primary & secondary)...Is it the same for my case..One router with primary link and second router with back link..i'm confused. Can you help me on.Thanks in advanceMohamed
Hi Martin,It's gonna be easier if we have one router with two links (primary & secondary)...Is it the same for my case..One router with primary link and second router with back link..i'm confused. Can you help me on.Thanks in advanceMohamed
Hi Martin,So, to implement the HSRP, we need to have a Switch behind...Last concern, for the backup link..for cost issue,This not going to be used unless the primary link goes down (no routing packet should cross the backup link)..is it enough with H...
Hi Martin,The HSRP will be setup on the two routers. The is a device (server) connected to these two routers..this server has two network card..one card (192.168.10.4)connected to the primary router and another (192.168.11.4) for the secondary router...
Hi,Could you please advise if the below configuration is correct; according to your recommendation?This is an example configuration for site1:Router1 (primary) interface Ethernet0 ip address 192.168.10.3 255.255.255.0 ip address...
