Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am going to design a network of a newly established University and the following is my requirements and present scenario. In this regard I need your help and I hope your input will help me to design a better network. I want solution completely on c...
I am going to design a network of a newly established University and the following is my requirements and present scenario. In this regard I need your help and I hope your input will help me to design a better network. I want solution completely on c...
I need a with following specifications for a Router Cisco 2821These are the specification for the module1000Base-LX/LH singlemode GBIC transceivers (operable over 1310nm or 1550nm range)I tried to find it but I could not please help me in this regard...
I am getting 8 Mbps of Internet bandwidth from Service Provider throuth 4 e1 ports and I have Cisco 2821 Router with 4 E1 ports and built-in 2 ports giga bit Ethernet. I want that all my bandwidth (8 Mbps) should terminate on my one gigabit Ethernet ...
Each block will have 50 nodes.Yes we do have different path from server room to admn block but at this time the fiber cable goes from Server room to video conferencing block and then admn block. In future we will expand our fiber from admin block to ...
Thanks to allNice work. I have asked the service provider that may i use HWIC-1GE-SFP in place of GBIC. I hope he will reply shortly.One more thing to ask here that the Service Provider also said the module should be single mode but for HWIC-1GE-SFP ...
Dear Giuseppe,actually i have 8 mbps and i want to terminate 4 mbps(internet bandwith from 2 e1 port) bandwidth on one GE port and other 4 mbps(bandwith from 2 e1 port) on other GE. In this case what should i do.
