Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have the need to map/translate/bridge VLANs which come in from a WAN/Metro circuit to our internal VLAN convention. The protocols which run over Ethernet are mostly IP but there are might also some other non IP protocols. E.g. the scenario is
...
Hi, so I figured out how to obtain a ipv6 prefix from my ISP (Timewarner) on my WAN router WAN interface.interface GigabitEthernet8 description WAN ... ipv6 address dhcp ipv6 enable ipv6 nd autoconfig default-route ipv6 tcp adjust-mss 1360 ipv6 dhcp ...
The PVDM4 Q&A says:Q. Where are the PVDM4 DSPs installed?A. Unlike previous generations of PVDM2 and PVDM3 DSP modules, the PVDM4 modules are installed directly on the T1/E1 NIM. Depending on the number of channels required, the appropriate DSP modul...
Hi,I have two routers. One connects a leased on a serial interface, the other connects the ISDN backup lines (BRI with Dialer interface). Goal is to have a hot standby / backup solution between this two links. If LL goes down, ISDN should dial. First...
I guess that's of course an important point: the mentioned tool would be ok but only once the bug list would be entirely public visible (and bugs are properly associated with each release if affected or not). And of course it would be almost impossib...
Although the list of bugs fixed in 8.2MR2 is pretty long the list of bugs fixed in 8.0MR3 and forthcoming on 8.0MR4 is even longer.
That raises of course question which of the bugs fixed in 8.0MR3/4 are also present in 8.2MR2 and are might not yet ad...
There is now a new file in the download section which is smaller and seems to follow different version schema.
The latest beta seem to have been 8.2.102.134. The new smaller file is 8.2.100.8. What is the beta to use?
Is there an updated list for the...
