Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am having a little problem setting up meet me. I have setup the conference bridge using this link http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00801ecf8a.html And have setup the Meet Me number ...
Hi,I am having a little problem setting up meet me. I have setup the conference bridge using this link http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00801ecf8a.htmlAnd have setup the Meet Me number i...
I have a phone that up until today was working fine. Now when the user goes to transfer a call the transfer button is not functional and is slightly greyed out. If you press it enough it says that this button is not active here. i hva reset the ph...
Hi Cris,We are experiencing a similar problem. The only difference being is that we have 2 BRI lines coming into the 2821 and it happens on every second call. I have checked with BRI supplier and have them run checks and they have come back saying ...
Hi,Have you thought about using internal Mesh access points? The 1242 is designed so taht it can be used as an internal mesh point. I am actually using it and it works well.Hope this helps Liam
Hi,Sorry if this info sounds obvious but best to check. You say you have created the WLAN SSID for guest and the dynamic interface for the appropriate VLAN and mapped them so that is OK. Have you enabled the WLAN and the SSID broadcast under the WL...
Sorry aokanlawon & javalenc, I am a bit new to the forums and ratings and wanted to give points to both and individual responses. Did not realise that by ticking that the first one resolved my problem that i would not be able to add any more points....
Thanks for all your help. Added in the following lines and all seems ok nowdtmf-relay h245-alphanumeric ip qos dscp cs5 media ip qos dscp cs4 signaling no vadThanks again
