Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hola Forum,In first place, please sorry me if this is not the correct forum to do this kind of question, and if so I would appreciate if you can point me where to do this question.Well I was reading a couple of Cisco links and playing with router to ...
Hello,QoS Gurus, I need your attention please.I?m having a hard time to understand the values of Normal Burst and Exceed Burst. I know that those values are in Bytes and that the Token Bucket (same as Bc+Be) is used as a metaphor to explain how token...
Hello I was reading this link http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a00800ae96a.shtmlTrying to understand the Load Balancing PartI looked to more configurations about this, and I got completely lost.For Example ...
DSLW Direct / Lite Encapsulation QuestionHello please I have this confusion with DSLW.Ok suppose this topology: Let say: ===========PVC 300 ============= DLCI DLCIRtr-A -s0/0 - F-RELAY NETWORK - s0/0 Rtr B -AA...
Ok no money to buy an ISDN Simulator to play But trying to think out of the box, can I use a couple off routers using an ISDN Intef, and connect them Back-to-Back? (I’ll hope this does not burn's my routers
Martin, thank you so much for your explanation, Just another question, If I use FRF.12 do I need to have a method to distinguish between unfragmented packets?like frame-relay ip rtp??, using WFQ and RSVP??
Hi..You can push your traffic to flow to that loopback please see this example.interface Loopback0 ip address 150.1.5.5 255.255.255.0 ip nat outside!interface Ethernet0/0 ip address 204.12.1.5 255.255.255.0 ip nat inside!ip local policy route-map POL...
Policing could also transmit exceeded Burst not conforming to the Exceed Burst Byte configured, for example set the Precedence Value to Best EffortThe real difference is that Shaping give the promise to buffer traffic for latter trasmittion, while p...
Hi there,You could use something like thismls qosmls qos aggregate-policer 1MB 1000000 8000 exceed-action drop!access-list 100 permit ip any any!mac access-list extended NON_IPpermit any any!class-map match-all NON_IPmatch access-group name NON_IP!cl...
