Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Community,I am using cisco WLC 9800 and WLAN is configured to use Local dot1x authentication.where can i see the local users configured for this authentication.from GUI i am not able to find the local users section for this.Thanks in advance.
Hello All,Iam facing a strange issue from last 1 month.I have Wireless network running with WLC2504 and AP AIR-1832IScenario is I have AP in 1st floor corridor and another AP in ground floor area.We have one conference room near first floor corridor ...
Hello all,facing a strange issue with WiFi network, everything works fine during weekdays and during weekend we get issues with WiFi network.I see AP has been reset by controller for some times.any suggestions what can be checked.
Hello Everyone,I wanted to know what is the difference between OSPF priority command in interface and router mode config.suppose i did neighbor x.x.x.x priority 0 what will happen.As i know if i do same command in interface - interface eth 0/0ospf pr...
Hello All,I have 3 ospf point to point routers connected with switch in between.I observed only 2 routers can form neighborship at the time, example R1 can form neighbor with R2 or R3 at the time.Can anyone explain why this behaviour.Find the attach...
HI @Mark Elsen Thanks for your valuable suggestions.What if the device does not come up after upgrade then entire wifi network will be down right.Then i cannot even reach to cisco for this as this is EOL product.
M02@rt37 Thanks for sharing the link.I have gone through the link and it works fine.so basically we do not need to configure phase 2 interesting traffic ofr ospf over ipsec?interesting traffic will be taken based of routing?
Iam just trying to understand how ipsec will handel ospf communication over point=to-point links.As fortigate or any other firewalls does not required gre over ipsec for ospf to run.then how traffic will be handelled for ospf neighborship.
