Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Community,I am facing an issue with Wireless networking 2.4Ghz and 5Ghz is not coming ap on AP3802I-D-K9 Access point with c9800CL virtual WLC.I am not sure what is wrong in this.,
Hello Community,I am using cisco WLC 9800 and WLAN is configured to use Local dot1x authentication.where can i see the local users configured for this authentication.from GUI i am not able to find the local users section for this.Thanks in advance.
Hello All,Iam facing a strange issue from last 1 month.I have Wireless network running with WLC2504 and AP AIR-1832IScenario is I have AP in 1st floor corridor and another AP in ground floor area.We have one conference room near first floor corridor ...
Hello all,facing a strange issue with WiFi network, everything works fine during weekdays and during weekend we get issues with WiFi network.I see AP has been reset by controller for some times.any suggestions what can be checked.
Hello Everyone,I wanted to know what is the difference between OSPF priority command in interface and router mode config.suppose i did neighbor x.x.x.x priority 0 what will happen.As i know if i do same command in interface - interface eth 0/0ospf pr...
so you mean 17.9.9 does not support this AP model.if thats the case i can upgrade from 17.9.9 to 17.12.7.can you please let me know what is the issue with AP join profile, so i can correct this.can how to get the complete full boot sequence of the ac...
