Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are running OSPF routing protocol and we want to dvertise only the two summarize routes 10.8.0.0/16 and 10.4.0.0/16 on our perimeter devices(cisco routers) which are connected to our collabarative network.Is it possible to advertise two sumarize r...
Dear support guys,Can we advertise only the two summarize routes 10.8.0.0/16 and 10.4.0.0/16 on our CISCO routers which are connected to our collabarative network?
Dear NetPro team,We are trying to connect one of our access switch which are running on CATOS with distribution switch which are running on IOS but couldn't work out. The attached are the configuration from our distribution switch dont know much abou...
Could you please tell me how we can see hostnames of OSPF routers in an output of 'show ip ospf neighbours'.What is the command we can put in OSPF configuration? Please advice.
Team,I have configured port-channel88 on catalyst 6509-E switch but when i tried to configure the this channel on tengigabit interface getting the following error message. ***************************************ERROR MESSAGE**************************...
Aijaz,Thanks for your reply. Is there any documentation for this on cisco site for more details because i need to see cisco documentation before i modify the configuration.Sure i will rate your comment.Regards,
